Polyurethane Architectural Elements Value and Design come together to create a line of polyurethane millwork designed to give all your projects a distinctive finish ...a designers finish. Suggested Ceiling Medallions Polyurethane Installation Place a solid bead of premium adhesive around and about the Polyurethane mouldings may be installed much the same way you backside of the medallion. Pressing the medallion into place, it would install wood mouldings. For a better fit, it is advised that may then be secured with 4 trim head dry wall screws. Be sure a flat or "Butt Joint" is used to join longer lengths of polyurethane to place the screws so that any holes created may be filled and mouldings. Cut all pieces 1/8th of an inch longer than the sanded with minimal effort. required measurement, fitting the ends in place first and the Finishing middle sections last. Always place a continuous bead of premium Before installing moulding, lightly sand and wipe material to avoid polyurethane adhesive along all adjoining wall and ceiling any dirt and impurities. This is important to obtain good adhesion surfaces before final positioning of the moulding. Poly-glue is and a smooth finish. Comes primed white and ready to finish with essential when attaching one length of moulding to the next. a good quality oil or latex based paint. A pneumatic pin nailer works well for fastening polyurethane * FRT PRE-PAID ON ORDERS OF $100.00 OR MORE! mouldings to wall and ceiling surfaces; alternatively, trim head (unless otherwise specified) drywall screws or finishing nails may be used. (GROUND ONLY-NO COD ORDERS) Filling and Sanding (Within continental U.S.- Excludes AK and HI) *APPLIES TO "DEM" Series Once all of the mouldings are fixed in place, fill any joints or Designers Edge Millwork; other items will not remaining voids with a paintable siliconized latex caulking. This qualify and will be packed and shipped separately. same caulking may be applied sparingly along the top and bottom The FRT PRE-PAID offer does NOT apply edges of the moulding where it meets the ceiling and wall. A damp to the DEM-900 Series of ceiling domes. cloth or silicone coving tool may be used to clear away any excess caulking to leave a clean professional look. Any remaining nail or screw holes may be filled with sandable, ADH1 $4.66 per 10.6 oz tube paintable non-shrinking filler. Be careful not to over sand the PL Premium Adhesive surfaces of your polyurethane mouldings. Sanding past the Approximate adhesive yields* protective barrier undercoating may necessitate further filling Mouldings 2" + Under - 60' and sanding to maintain a paintable surface. Mouldings 2 - 5" - 45' Mouldings 5" + Over - 30' * yields are approximate and based on average conditions and installation technique. M-663 Architectural Products by Outwater L.L.C. Phone:1-800-835-4400/Fax:1-800-835-4403